Beluga Little Pool Heater Solar Heating Device

Introducing the Beluga Solar Pool Heating Device: Revolutionize Your Pool Heating Experience!

Simply attach the Beluga device to a standard 1.5-inch return fitting on your above ground or inground swimming pool, and redirect a small stream of water into a garden hose. As the water flows through the hose, it absorbs the heat generated from being exposed to sunlight.

The longer the water stays in the hose, the warmer it becomes upon exiting. Maximize your water temperature by using the longest hose that fits your space, and adjust the water flow to optimize the stream size during the hottest time of the day. For even better results, combine the Beluga with a pool solar cover.

Experience the convenience, affordability, and efficiency of the Beluga Solar Pool Heating Device today! Make the most of your pool time and enjoy comfortable swimming temperatures without breaking the bank.

Features:

• Heat your pool using a garden hose
• Save significant amounts on your energy bill
• Easy connection to standard 1 1/2" return fitting
• Suitable for in-ground or permanent above ground pools
• Enhance pool comfort and extend the swimming season
• Economical alternative to gas or electric heating methods

Installation Requirements:

• Circulation pump
• 1.5" threaded connector at the water inlet to the pool
• Garden hose (black rubber hoses recommended)

Instructions for Use:

• Turn off the pool pump
• Screw the device into the pool inlet
• Connect a garden hose to the device's outlet at the top
• Place the hose in a sunny area
• Position the hose's end over the pool
• Turn the pump back on
• Adjust the cap on the device's face toward a closed position to direct water into the garden hose. It may require firm closure to fill the hose
• Once water starts flowing from the hose's opposite end, adjust the flow to approximately a 1/2" diameter or smaller stream
• Always ensure the hose's discharge end is securely positioned over the pool. Remove the device when the pool is in use and refer to your pool pump manual for installation guidance
• Do not use the device for water lifting exceeding 5 feet from the pool inlet